Table of Contents
Advertisement
3. Do one of the following:
• If you are adding a transceiver: Loosen the captured screws
on the cover plate over the transceiver slot until they disengage
from the module, then remove the cover plate and store it for pos-
sible future use.
• If you are removing a previously installed transceiver:
1) Use a flat-bladed or Torx T-10 screwdriver to loosen the
spring-loaded retaining screws on the transceiver bulkhead.
2) Slide the transceiver out of the module and place it in an antis-
tatic container for protection from electrostatic discharge
(ESD).
4. Do one of the following:
• If you are adding a new transceiver or replacing one trans-
ceiver with another:
1) Use the instructions provided with the transceiver to install it
in the module.
2) Re-Install the module in the Switch 2000 using the instructions
under ''Installing a Module in an Unused Slot'' on page 2 and
begin with step 3.
• If you are removing a transceiver without replacing it with
another transceiver:
1) Use a flat-bladed or Torx T-10 screwdriver to install an HP
10Base-T transceiver cover plate over the transceiver slot in
the module.
2) Re-Install the module in the Switch 2000 using the instructions
under ''Installing a Module in an Unused Slot'' on page 2 and
begin with step 3.
Installation
13
Advertisement
Table of Contents
