Table of Contents
Advertisement
Installation
9. Customize the port configuration, if necessary. (See "Customizing the
10. Reboot the switch, since this is a new module being installed. (See
Customizing the Port Configuration
If the slot in which you installed the Switch Ethernet Module was empty the
last time the switch was either rebooted or reset (or the power to the switch
was cycled), then the module will use preconfigured default parameter
values that will work for most networks.
The default 10Base-T port configuration is:
If necessary, configure the port(s) in the module by using the switch console
interface. (See the Console User's Guide—HP part number
5964-4644—shipped with the Switch 2000, and the online Help provided in
the console interface itself.)
If the default port configuration, shown above, is correct for your network,
then skip this process.
8
Port Configuration", below.)
"Rebooting the Switch" on page 9 for more information on when the
switch must be rebooted.)
Enabled: Yes
Mode: Half Duplex
(Full Duplex can be set on any of the built-in RJ-45 ports, but not a
transceiver that is installed and used as port 1.)
Trunk (port trunking): None
Broadcast Limit: 0
Advertisement
Table of Contents
