Table of Contents
Advertisement
C a u t i o n
5. Do one of the following:
• If you will be installing another module in the slot, go to ''Install-
ing a Module in an Unused Slot'' on page 2 and begin with step 3.
Make sure that you install the proper LED strip for the new
module you are installing, as described in step 1 on page 2. If
you do not install the correct LED strip for the module you have
installed, the LED display will be incorrect for that module.
• If you will not install another module in the slot (that is, leave it
empty), then re-attach a slot cover plate over the empty slot open-
ing, and replace the LED strip for that slot with a blank LED strip.
6. If you are removing a module, or replacing a module with a different
type (for example, replacing an Ethernet module with a 100VG
module), then reboot the switch as described under "Rebooting the
Switch" on page 9.
For proper cooling and reduction of electromagnetic emissions, ensure
that a slot cover (provided with your Switch 2000) is installed on any
unused port or transceiver slot.
Installation
11
Advertisement
Table of Contents
