Electronic Speed Control - Fiat 500 2016 User Manual

OPERATING YOUR VEHICLE
Rear Windshield Wiper
Rotate the end of the windshield wiper/washer lever upward to the first detent past the
intermittent settings for intermittent wipe operation. With the front windshield wiper
active, rotate the end of the windshield wiper/washer lever upward. The rear wiper will
operate in the same mode as the front windshield wipers, but at half the frequency.
When the transmission is shifted into REVERSE, the rear wiper will automatically operate
at Low Speed and return to normal operation when the transmission is shifted out of
REVERSE.
NOTE:
The windshield wipers/washers will only operate with the ignition in the ON/RUN posi-
tion.
Rear Windshield Washer Operation
Push the windshield wiper/washer lever toward the instrument panel to activate the rear
washer. Push and hold the lever for more than a half second and the wipers will activate
automatically for three cycles after the lever is released.

ELECTRONIC SPEED CONTROL

When engaged, the Electronic Speed Control takes over accelerator operations at speeds
greater than 25 mph (40 km/h).
The Electronic Speed Control buttons are located on the right side of the steering
wheel.
NOTE:
In order to ensure proper operation, the
Electronic Speed Control system has been
designed to shut down if multiple Speed
Control functions are operated at the same
time. If this occurs, the Electronic Speed
Control system can be reactivated by push-
ing the Electronic Speed Control ON/OFF
button and resetting the desired vehicle set
speed.
To Activate
Push the ON/OFF button. The Cruise Indi-
cator Light in the instrument cluster will
illuminate. To turn the system off, push the
ON/OFF button a second time. The Cruise
Indicator Light will turn off. The system
should be turned off when not in use.
32
Electronic Speed Control Buttons
1 — Push ON/OFF
2 — Push Resume +/Accel
3 — Push Set –/Decel
4 — Push Cancel