Hibernation Mode; Symptom-To-Fru Index - Lenovo ThinkPad P70 Hardware Maintenance Manual

• The internal storage drive is powered off.
• The microprocessor stops.
To enter sleep mode, press Fn+4 or do the following:
• For Windows 7: Open the Start menu, then click the arrow next to the Shut down button. Click Sleep
from the menu displayed.
• For Windows 10: Open the Start menu, click
In certain circumstances, the computer goes into sleep mode automatically:
• After a period of inactivity specified in power plan settings
• When the battery power is low
To resume the computer from sleep mode, press the power button.
Also, in either of the following events, the computer automatically returns from sleep mode and resumes
operation:
• The ring indicator (RI) is signaled by a serial device or a PC Card device.
• The time set on the resume timer elapses.
Note: The computer does not accept any input immediately after it enters sleep mode. Wait a few
seconds before taking any action to reenter operation mode.

Hibernation mode

In hibernation mode, the following occurs:
• The system status, RAM, VRAM, and setup data are stored on the hard disk.
• The system is powered off.
Note: If the computer enters the hibernation mode while it is docked to the docking station, do not undock it
before resuming normal operation. If you do undock it and then try to resume normal operation, you will get
an error message, and you will have to restart the system.
If you have defined one of the following actions as the event that causes the system to go into hibernation
mode, perform that action.
• Closing the lid.
• Pressing the power button.
Also, the computer goes into hibernation mode automatically after a period of inactivity specified in power
plan settings.
When the power is turned on, the computer returns from hibernation mode and resumes operation. The
hibernation file in the boot record on the HDD is read, and system status is restored from the HDD.

Symptom-to-FRU index

This section contains following information:
• "Numeric error codes" on page 43
• "Error messages" on page 44
• "Beep symptoms" on page 45
• "No-beep symptoms" on page 46
• "LCD-related symptoms" on page 46
• "Intermittent problems" on page 46
42
ThinkPad P70 Hardware Maintenance Manual
Power, and then click Sleep.