Using The Device To Log In To A Telnet Server; Setting The Dscp Value For Outgoing Telnet Packets When The Device Acts As The Telnet Client - HP 5830 Series Configuration Manual

Using the device to log in to a Telnet server

You can use the device as a Telnet client to log in to a Telnet server. If the server is located in a different
subnet than the device, make sure the two devices have routes to reach each other.
Figure 15 Telnetting from the device to a Telnet server
To use the device to log in to a Telnet server:
Step
1. Enter system view.
2. Specify a source IPv4 address
or source interface for
outgoing Telnet packets.
3. Exit to user view.
4. Use the device to log in to a
Telnet server.
Setting the DSCP value for outgoing Telnet packets when the
device acts as the Telnet client
Step
1. Enter system view.
2. Set the DSCP value for
outgoing Telnet
packets when the
device acts as the
Telnet client.
Command
system-view
telnet client source { interface
interface-type interface-number | ip
ip-address }
quit
•
Log in to an IPv4 Telnet server:
telnet remote-host
[ service-port ] [ vpn-instance
vpn-instance-name ] [ source
{ interface interface-type
interface-number | ip
ip-address } ]
•
Log in to an IPv6 Telnet server:
telnet ipv6 remote-host [ -i
interface-type
interface-number ]
[ port-number ] [ vpn-instance
vpn-instance-name ]
Command
system-view
•
On a Telnet client running IPv4:
telnet client dscp dscp-value
•
On a Telnet client running IPv6:
telnet client ipv6 dscp dscp-value
40
Remarks
N/A
Optional.
By default, no source IPv4 address
or source interface is specified.
The IP address of the outbound
interface is used as the source IPv4
address.
N/A
Use either command.
Remarks
N/A
The default is as follows:
•
16 for a Telnet client running IPv4.
•
0 for a Telnet client running IPv6.