Motorola E815 Service Manual page 30

Disassembly
30
3. To prevent damage to the speaker, insert an Exacto knife blade between the
metal stiffener and the earpiece gasket. Apply pressure to the speaker with
the side of the blade and hold it firm.
Figure 18. Removing the Display Bezel
4. Rotate the display bezel away from the barrel, pivoting on Latch #5 as shown
in photo. Continue lifting until the metal stiffener separates from the speaker.
Then, remove the Exacto knife blade.
5. Once the bezel has separated from the speaker, work the display bezel off latch#
5.
6. Remove old speaker gasket material. A new speaker gasket will be used for
reassembly. Ensure that the felt cover on the speaker assembly is not damaged
while removing the gasket material.
7. To replace, align the connector with it's socket on the transceiver board.
8. Gently press the flex connector into position onto the flex connector socket.
9. Lower the new display bezel over the display module. Gently and firmly press
the latches into position. Ensure all the latches are engaged.
10. Replace the flip knuckle, flip assembly sleeve, flip assembly, flip display lens,
transceiver board, flip assembly, keyboard stiffener, speaker cover, keypad
bezel, antenna, battery, and battery cover as described in the procedures.
January 24, 2006
Metal stiffener
Knife blade
E815, E816 CDMA
Latch #5
032218o
6809492A18-B