Motorola E815 Service Manual page 25

Level 2 Service Manual
6809492A18-B
5. Turn the transceiver board and rear assembly over and lift the transceiver
board away from the rear housing..
transceiver board
Figure 13. Removing the Transceiver Board
6. To replace, align the transceiver board to the rear housing assembly and lower
it into place on the rear housing.
7. With the flip assembly knuckles in the "flip open" position, align the flip
assembly flex connector to the transceiver board.
8. Connect the flip assembly flex connector to its socket on the transceiver board.
9. Align the flip assembly screw bosses to the screw holes on the transceiver
board.
10. Hold the assembly together and insert the flip assembly screws into the rear
housing assembly and tighten to 14 Ncm (1.25 inch-pounds).
11. Replace the keyboard stiffener, speaker cover, keypad bezel, antenna, battery,
and battery cover as described in the procedures.
January 24, 2006
Disassembly
032216o
25