Optoma S310e User Manual page 33

No Symptom
Dead Pixel/Dust
10
(Out of spec.)
11 Garbage Image
Remote Controller
12
Failed
13 Function Abnormal
Audio Abnormal
14 (For the projector has
speaker)
15 3D Image Abnormal
- Ensure the projection screen without dirt
- Ensure the projection lens is clean
- Clean DMD Chip and Engine Module
- Check DMD Chip
- Check Engine Module
- Ensure that the signal cables and source work as well
- Check Main Board
- Remote Controller
a. Check Battery
b. Check Remote Controller
c. Check IR Sensor Board
d. Check Main Board
"
- Do Reset (All data)
- Check Main Board
- Daughter Board Daughter Board
- Ensure that the signal cables and source are work as well
- Ensure that your Projector is not in "Mute" mode
- Check Main Board
- Daughter Board
- Check Speaker
- Ensure the using 3D glasses is good and you must face the Ensure the using 3D glasses is good and you must face the
projection.
- Ensure the signal source is 3D format.
- Ensure the 3D function of projector OSD is on and 3D sync
invert is on.
- Check Main Board.
Procedure
"
of the OSD Menu
S310e/X312
Confidential
3-4