Connecting The Lcd Monitor And Base; Viewing Angle Adjustment; Detaching Lcd Monitor From Its Stand; Interface For Arm Applications - Planar PL1910M User Manual

Connecting the LCD Monitor and Base

When you open the box to take the base and put on the desk first. Then
connect the LCD Monitor and base please. (See fig.1-1 )

Viewing Angle Adjustment

The LCD Monitor is designed to allow users to have a
comfortable viewing angle. The viewing angle can be adjusted
from -5°to +25°.(See fig. 1-2)
Warning: Do not force the LCD Monitor over its maximum viewing angle settings as stated above. Attempting
this will result in damaging the Monitor and Monitor stand.

Detaching LCD Monitor from Its Stand

Unscrew screws the swivel base support column and pull down
second.

Interface for Arm Applications

Before installing to mounting device, please refer to Fig.1-3.
The rear of this LCD display has four integrated 4 mm, 0.7 pitches
threaded nuts, as well as four 5 mm access holes in the plastic covering
as illustrated in Figure 1-4. These specifications meet the VESA Flat
Panel Monitor Physical Mounting Interface Standard (paragraphs
2.1 and 2.1.3, version 1, dated 13 November 1997).
Note :Please using Ø 4mm x 8mm (L) screw for this application.

Connecting the Display to your Computer

1. Power off your computer.
2. Connect one end of the signal cable to the LCD Monitor's VGA port
or DVI port.(See Fig 1-5)
3. Connect the other end of the signal cable to the VGA port or DVI port
on your PC.
4. Make sure connection are secure.
the
5
Figure 1-1
Figure 1-2
Figure 1-3
100mm x100mm
Screw Mounting Options
100mm
100mm
4mm ,0.7pitch threaded holes x4
Figure 1-4
Figure 1-5