Connecting The Lcd Monitor And Base; Viewing Angle Adjustment; Connecting The Display; Connecting The Ac Power - Planar PL1700 User Manual

Connecting the LCD Monitor and Base

When you open the box to take the base and put on the
desk first. Then connect the LCD Monitor and base
please.(See fig.1-1 )

Viewing Angle Adjustment

The LCD Monitor is designed to allow users to have a
comfortable viewing angle. The viewing angle can be
adjusted from -5°to +30°.(See fig. 1-2)
Warning
Do not force the LCD Monitor over its maximum viewing angle settings as stated above. Attempting this will result in
damaging the Monitor and Monitor stand.

Connecting the Display

1.
Power off your computer.
2.
Connect one end of the signal cable to the LCD Monitor's VGA
port. (See Fig 1-5)
3.
Connect the other end of the signal cable to the VGA port on
your PC.
4.
Make sure connections are secure.

Connecting the AC Power

1.
Connect the power cord to the LCD Monitor. (See Fig. 1-6)
2.
Connect the power cord to an AC power source.

Connecting the Audio Cable (PL1700M)

1.
Connect the audio cable to the "LINE OUT" jack on your PC's
audio card or to the front panel's "AUDIO OUT" jack of your
CD ROM drive. (See Fig. 1-7)
2.
Connect the other end of the audio cable to the LCD Monitor's "
LINE IN " jack.

Setting Up the LCD Monitor

1.
Make sure the AC power cord is connected to the LCD Monitor.
2.
Turn on the LCD Monitor's power switch, located on the bezel of the monitor.
4
Figure 1-1
Figure 1-2
Figure 1-5
Figure 1-6
Figure 1-7