Updating Of The Firmware - Pioneer XDJ-RX Service Manual

1

8.2 UPDATING OF THE FIRMWARE

A
Note:
If the power cord is disconnected during updating, perform updating again after the unit is turned on the next time. Then you
can operate the unit normally.
You cannot operate the unit normally without reperforming updating.
Procedure
1 Copy an update file (XDJRX.UPD) to a root folder of USB device.
2 Turn on the power, pressing the DECK 1 USB STOP, DECK 1 RELOOP/EXIT buttons.
(Be sure to hold the @ switch pressed until the unit starts up.)
B
RELOOP/EXIT button
C
3 Insert the USB device which you wrote in an update file at with procedure 1.
4 Update is started.
D
E
5 Update is completed, and displayed "Firmware update is complete."
F
60
1
2
USB STOP button
2
3
u switch
XDJ-RX
3
4
4