Service Mode; Test Mode - Pioneer XDJ-RX Service Manual

1

6. SERVICE MODE

6.1 TEST MODE

Description of Test Modes
A
The Following seven test modes are provided for this unit:
1 Mode 1 : Confirmation of the versions, destination (language), MAC address, and JOG UCOMs
2 Mode 2 : All LEDs and LCDs unlit
3 Mode 3 : All LEDs and LCDs lit
4 Mode 4 : LCD patterns
5 Mode 5 : Confirmation of individual keys and LEDs
6 Mode 6 : Confirmation of individual switches
7 Mode 7 : Confirmation of the values of the rotary variable controls and sliders
8 Mode 8 : Rotary selector
B
How to Enter Test Mode (Other than Entering WLAN TEST Mode)
While holding the DECK 1 MEMORY and DECK 1 TEMPO RANGE buttons pressed, press the u switch to turn the unit on.
(Be sure to hold the u switch pressed until the unit starts up.)
Start up the unit in Mode 1 of Test mode.
C
How to Change Test Modes
To change Test modes, turn the Rotary selector clockwise or counterclockwise.
D
To shift from Mode 8 to Mode 1 or from Mode 1 to Mode 8, press the Rotary selector.
Then, Test modes can be changed again with a turn of the Rotary selector.
Mode 1 Mode 2
Test mode Contents
1 Mode 1: Confirmation of the versions, destination (language), MAC address, and JOG UCOMs
If the JOG UCOM is in failure, an error message will be displayed; if it is OK, no message will be displayed.
E
The example screen below indicates that the JOG UCOM on DECK 1 is in failure and that on DECK 2 is OK.
If either of the JOG UCOMs is in failure, no operation can be performed.
To operate the unit, press the BEAT EFFECT ON/OFF button.
F
36
1
2
u switch
Mode 3 Mode 4
XDJ-RX
2
3
MEMORY button
TEMPO RANGE button
Mode 5 Mode 6
3
4
Mode 7 Mode 8
4