Table of Contents
Advertisement
SPORTCITY CUBE 250 - 300
- Check clearances on the connection between the
chassis-side arm and the chassis using a thick-
ness gauge.
- If values non-conforming with those specified are
measured, remove the arm and replace the Teflon
spacer bushings.
Characteristic
Clearance between bushing and plates
Min: 0.6 ; Max: 1.2 mm
- In order to check silent-blocks, unscrew the nut
from inside, undo the screw and remove the silent-
block.
- Check that they are not broken. Otherwise, re-
place them.
- In order to remove the roller casings, remove the Teflon spacer bushing and the internal spacer «A».
- Use a suitable plug to remove the roller casings «B».
- Using a specific tool, drive the new roller casings being careful to position the bearings with the sealing
rings facing outwards.
- Once the ball bearing cages have been fitted, lubricate them with the recommended product.
Specific tooling
020115Y ø 18 punch
020244Y ø 15 punch
Recommended products
AGIP GREASE PV2 Grease for steering bearings, pin seats and swinging arm
White anhydrous-calcium based protective grease for roller bearings; temperature range between -20
C and +120 C NLGI 2; ISO-L-XBCIB2.
Suspensions
SUSP - 217
Advertisement
Table of Contents
