Measuring A Workpiece - Siemens SINUMERIK 828D Manual

4.3

Measuring a workpiece

The workpieces can be measured as follows:
Edge finder, dial gauge, reference tool
3D switching probe.
The following measuring cycles are available:
Calibrate probe
Point measurement for edges
Orienting the edge (angle)
Inner/outer corner (3 or 4 points)
Orienting the edge by means of 2 holes/spigots
Rectangular or circular pockets, rectangular or circular spigots
Center point of 3 or 4 holes or spigots
Orienting the plane with three points
The measurement results can be output in a measuring log (see Chapter Logging
measurement results in JOG (Page 33)).
Benefits
Time saving due to user-friendly determination of the workpiece's clamping position
instead of orienting the workpiece by hand.
The measurement results can be output in a measuring log.
SINUMERIK Operate - Milling
Control system overview for machine tools' sales people, 2017, A5E41992599B AA
SINUMERIK 828D
BASIC
Basic configuration
SINUMERIK 840D sl
BASIC
Basic configuration
CNC operation in manual mode (JOG)
SINUMERIK 828D
Basic configuration
SINUMERIK 840D sl
Basic configuration
4.3 Measuring a workpiece
SINUMERIK 828D
ADVANCED
Basic configuration
31