Channel Level - Pioneer Elite VSX-37TX Operating Instructions Manual

Channel Level

The following steps show you how to balance the sound output level of your speakers. Proper speaker
balance is essential for obtaining high quality surround sound. If continuing from Channel Delay go to step
1. If starting fresh, complete steps 1-3 in "Setting Up for Surround Sound" (p.29) first.
Î
USE SETUP
S0URCE RECEIVER
MULTI SYSTEM
OPERATION OFF
DVD/LD TV/SAT VCR1 VCR2
MULTI CONTROL
MD/
CD TUNER TVCONT
TAPE1
CLASS MPX BAND DIRECT ACCESS
¶ 7 3 8
- + - +
TUNING STATION
1 ¡ 4 ¢
- +
DTV ON/OFF DTV MENU CHANNEL
1 2 3
4 5 6
7 8 9
GUIDE
EXIT
0
ENTER
+10 DISC
+ +
TV
TV VOL TV CONTROL VOLUME
– –
TV FUNC
REMOTE SETUP
INPUT
MENU MUTE
ATT
SYSTEM SETUP
EFFECT/ + FUNCTION
CH SEL
ENTER
DIGITAL
– SIGNAL
NR SELECT
MULTI CH
STEREO/
MIDNIGHT DSP
INPUT
DIRECT
/DTS
LIGHT THX ADVANCED STANDARD
AV PRE-PROGRAMMED AND LEARNING
REMOTE CONTROL UNIT
memo
A test tone will be output from the
SURROUND BACK speakers but your
external amplifier must be turned up
at least a little in order to hear it. Be
careful that it is not turned up too much
because the test tone volume is quite
loud.
1 Select CHANNEL LEVEL (if continuing from
CHANNEL DELAY, it will already be selected).
See "Setting Up for Surround Sound" on page 29 if you are
unsure how to do this.
Press the ENTER button.
Channel Level
Test Tone
[Setting Start
[EXIT]
NOTE : Be prepared! The test tone is output at a high
volume level.
2 Select a TEST TONE mode.
1 Press 2 or 3 to move the hand to AUTO or MANUAL.
1-3
2 Press ∞ button to select SETTING START.
AUTO (automatic TEST TONE)
This mode switches the test tone between each speaker
automatically. Use this mode when balancing the speaker
levels by ear.
The automatic test tone is output in the following order:
SW
MANUAL (manual TEST TONE)
This mode lets you switch the test tone between each speaker
manually. You can use this mode when you want to balance the
speaker levels by ear at a more leisurely pace.
3 After selecting SETTING START with the ∞
button press ENTER button. The TEST
TONE will be output.
These settings will be displayed on your TV.
Channel Level
Test Tone
[Setting OK
Front L L
Center
Front
R
Surround
Surr Back
Surr Back
Surround
Subwoofer
It takes a moment for the machine to set itself. MASTER
VOLUME rotates to the reference position (0 dB), and the test
tone is output.
To exit before outputting the TEST TONE
Press the ENTER button.
To exit while outputting the TEST TONE
Press the ENTER button.
[ AUTO ]
]
CT
FL
SL SBL SBR
SIGNAL
SELECT
[ AUTO ]
ANALOG SP A
] AUTO
[ 0.0dB]
[ 0.0dB]
[ 0.0dB]
[ 0.0dB]
R
[ 0.0dB]
R
[ 0.0dB]
L
[ 0.0dB]
L
[ 0.0dB]
Initial Set Up
FR
SR
STEREO
VOLUME
dB
35