Power Button Board - HP ProBook 440 G5 Maintenance And Service Manual

Power button board

Description
Power button board
Power button board cable (included in Cable Kit)
Before removing the power button board, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Place the computer in "Battery Safe mode"
3. Disconnect all external devices connected to the computer.
4. Disconnect the power from the computer by first unplugging the power cord from the AC outlet, and
then unplugging the AC adapter from the computer.
5. Remove the following components:
a. Service doors
b. Hard drive
c. Keyboard
d. Top cover
Remove the power button board:
1. Position the top cover upside-down.
2. Disconnect the cable from the connector on the board (1).
3. Remove the Phillips M2.0×3.0 screw (2) that secures the board to the top cover.
4. Lift the left side of the board (3), and then pull the board to the left (4) to remove it from under the tab
(5).
(Service doors on page
(Hard drive on page 41)
(Keyboard on page 44)
(Top cover on page 48)
(Battery Safe mode on page
33)
Component replacement procedures
Spare part number
L01044-001
L01082-001
32).
53