Sr+ Setup For Pioneer Plasma Displays; Digital Video Converter Setup - Pioneer VSX-917V-S/-K Operating Instructions Manual

Other Settings
3 When you're finished, press RETURN .
You return to the Other Setup menu.

SR+ Setup for Pioneer plasma displays

Make the following settings if you have
connected a Pioneer plasma display to this
receiver using an SR+ cable. Note that the
number of settings available will depend on the
plasma display you've connected.
See also Using this receiver with a Pioneer
plasma display on page 60.
1 Select 'SR+ Setup' from the Other Setup
menu.
6.Other Setup
a.DRC Setup
b.Dual Mono Setup
c.LFE ATT Setup
d.SR + Setup
e.DVC Setup
:Return
2 Select the 'PDP Volume Control' setting
you want.
• OFF – The receiver does not control the
volume of the plasma display.
• ON – When the receiver is switched to one
of the inputs that use the plasma display
(DVD/LD, or another function below), the
volume on the plasma display is muted so
only sound from the receiver is heard.
3 Assign any input source connected to the
plasma display to the corresponding input
number.
This matches the receiver's input source with a
numbered video input on the plasma display.
For example, assign DVD/LD to input-2 if you
have connected your DVD video output to video
input 2 on the plasma display.
• The Monitor Out Connect should be set
to the input that you've used to connect
this receiver to your plasma display.
6d.SR + Setup
PDP Volume Control
[ ON ]
PDP Input Select
DVD/LD input–1
TV/SAT [ input–2 ]
DVR [ input–3 ]
VIDEO [ TV ]
Monitor Out Connect
[ OFF ]
:Finish
6d.SR + Setup
PDP Volume Control
OFF
PDP Input Select
DVD/LD [ input–1 ]
TV/SAT [ input–2 ]
DVR [ input–3 ]
VIDEO [ TV ]
Monitor Out Connect
[ OFF ]
:Finish
6d.SR + Setup
PDP Volume Control
[ ON ]
PDP Input Select
DVD/LD input–2
TV/SAT [ OFF ]
DVR [ input–3 ]
VIDEO [ TV ]
Monitor Out Connect
[ OFF ]
:Finish
4 When you're finished, press RETURN .
You return to the Other Setup menu.

Digital Video Converter Setup

• Default setting: ON
The video converter allows you to see analog
video sources through all of this receiver's
MONITOR VIDEO OUT jacks. Note that the
converter gives priority to component, S-video,
then composite (in that order). See About the
video converter on page 13 for more on this.
1 Select ' DVC Setup' from the Other Setup
menu.
6.Other Setup
a.DRC Setup
b.Dual Mono Setup
c.LFE ATT Setup
d.SR + Setup
e.DVC Setup
:Return
2 Choose the setting that you want.
• ON – All analog video signals are output
from the MONITOR VIDEO OUT jacks.
• OFF – No conversion between video
formats.
3 When you're finished, press RETURN .
You return to the Other Setup menu.
6e. DVC Setup
DVC ON
:Finish
12
65
En