Lfe Attenuator Setup; Sr+ Setup For Pioneer Plasma Displays - Pioneer Elite VSX-52TX Operating Instructions Manual

Other Settings
11
Note
• This setting works only with dual mono encoded
Dolby Digital and DTS soundtracks.
Tip
• While the receiver is in standby (using the front
panel), press the
holding down the TUNER EDIT button to change the
dual mono setting.

LFE Attenuator Setup

• Default setting: ATT 0 dB
Some Dolby Digital and DTS audio sources include ultra-
low bass tones. Set the LFE attenuator as necessary to
prevent the ultra-low bass tones from distorting the
sound from the speakers.
1 Select 'LFE ATT Setup' from the Other Setup
menu.
2 Choose the setting that you want.
• ATT 0dB – No limiting (recommended setting)
• ATT 10dB – 10dB of limiting
• LFE OFF – No sound from LFE channel
3 When you're finished, press RETURN.
You will return to the Other Setup menu.
66
En
STANDBY/ON button while
6. Other Setup
[ a. DRC Setup ]
[ b. Dual Mono Setup ]
[ c. LFE ATT Setup ]
[ d. SR+ Setup ]
[ e . Multi Room Setup ]
[ f . 12V Trigger Setup ]
6c. LFE ATT Setup
LFE ATT [ ATT 0dB ]

SR+ Setup for Pioneer plasma displays

Make the following settings if you have connected a
Pioneer plasma display to this receiver using an SR+
cable. Note that the number of function settings available
will depend on the plasma display you've connected.
See also Using this receiver with a Pioneer plasma display
on page 60 and Using the SR+ mode with a Pioneer
plasma display on page 61.
1 Select 'SR+ Setup' from the Other Setup menu.
6. Other Setup
[ a . DRC Setup
[ b . Dual Mono Setup
[ c . LFE ATT Setup
[ d . SR+ Setup
[ e . Multi Room Setup
[ f . 12V Trigger Setup
2 Select the 'PDP Volume Control' setting you
want.
6d. SR+ Setup
PDP Volume Control
PDP Input Select
DVD/LD
TV/SAT
DVR
VIDEO1
VIDEO2
Monitor Out Connect
• OFF – The receiver does not control the volume of the
plasma display
• ON – When the receiver is switched to one of the
inputs that use the plasma display (DVD/LD, or
another one of functions below), the volume on the
plasma display is muted so only sound from the
receiver is heard.
3 Assign any input source connected to the plasma
display to the corresponding input number.
This matches the receiver's input source with a
numbered video input on the plasma display. For
example, assign DVD/LD to input-2 if you have
connected the your DVD video output to video input 2 on
the plasma display.
• The Monitor Out Connect should be set to the input
that you've used to connect this receiver to your
plasma display.
6d. SR+ Setup
PDP Volume Control
[ ON ]
PDP Input Select
DVD/LD [ input-3 ]
TV/SAT [ TV ]
DVR [ input-1 ]
VIDEO1 [ OFF ]
VIDEO2 [ OFF ]
Monitor Out Connect
[ input-2 ]
4 When you're finished, press RETURN.
You will return to the Other Setup menu.
]
]
]
]
]
]
[ OFF ]
[ input-3 ]
[ TV ]
[ input-1 ]
[ OFF ]
[ OFF ]
[ input-2 ]
6d. SR+ Setup
PDP Volume Control
[ ON ]
PDP Input Select
DVD/LD [ input-2 ]
TV/SAT [ TV ]
DVR [ input-1 ]
VIDEO1 [ OFF ]
VIDEO2 [ OFF ]
Monitor Out Connect
[ input-2 ]