Securing The Front Speakers; Wall-Mounting The Surround Speakers - Pioneer S-RS3TB Operating Instructions Manual

Connect to the speaker terminals on the rear of
the speakers.
• For S-RS7TB front speakers:
Unscrew the terminals on the speaker and insert the
striped speaker wire into the red (+) terminal and the
other wire into the black (–) terminal as shown below.
Other half of speaker cable
• For all other speakers:
To connect, insert the striped speaker wire into the
red (+) terminal and the other wire into the black (–)
terminal as shown below.
red
black
Other half of speaker cable
WALL-MOUNTING THE SURROUND
SPEAKERS
Before mounting
• Remember that the speaker system is heavy and that
its weight could cause the screws to work loose, or
the wall material to fail to support it, resulting in the
speaker falling. Make sure that the wall you intend to
mount the speakers on is strong enough to support
them. Do not mount on plywood or soft surface walls.
• Mounting screws are not supplied. Use screws
suitable for the wall material and support the weight
of the speaker.
Striped half of speaker cable
Striped half of speaker cable
Mounting screw
(not supplied)
5 mm to 7 mm
• If you are unsure of the quality and strength of the
walls, consult a professional for advice.
• Pioneer is not responsible for any accidents or
damage that result from improper installation.

SECURING THE FRONT SPEAKERS

• Using the included screw, tightly secure the metal
catch to the backside of the speaker.
• Pass a commercially-available reinforced string
through the metal catch to securely support the
speaker to the wall. Be sure that the wall to which you
fasten the speaker is strong enough to support the
weight of the speaker. After fastening the speaker,
make sure that it does not fall over.
• The speaker can incur damage in the event of a fall.
• Do not attach the metal catch directly to the wall. It
should only be used in conjunction with reinforced
string to prevent the speaker from falling.
Reinforced strings
Pass two reinforced strings through the metal catches,
and fasten the speaker to the wall as shown above.
5 mm
10 mm
Metal catches
Backside of speaker
3
En