JVC TH-A25 Service Manual page 11

3.2 Front panel assembly section
3.2.1 Removing the front board (See Fig.15)
• Prior to performing the following procedures, remove the top
cover, tray door and front panel assembly.
(1) From the back side of the front panel assembly, remove the
five screws R attaching the FRONT board.
(2) Disconnect the wire from the connector
front board.
(3) Take out the front board from the front panel assembly.
3.2.2 Removing the power SW board
(See Fig.15)
• Prior to performing the following procedures, remove the top
cover, tray door, front panel assembly and front board.
(1) Remove the screw S attaching the power SW board.
(2) Take out the power SW board from the front panel
assembly.
Front board
UCW13 on the
R
UCW13 Wire Power SW board
Fig.15
S
(No.MB143)1-11