JVC RX-8030VBK Service Manual page 6

3.4 Removing the front panel assembly
(See Figs.4 and 5)
• Prior to performing the following procedures, remove the top
cover, rear panel and I/O board.
(1) From the top side of the main body, remove the tie bands
bundling the wires. (See Fig.4)
(2) Disconnect the wire from the connector
board. (See Fig.4)
(3) Disconnect the wire from the connector
Audio2 board. (See Fig.4)
(4) Disconnect the wire from the connector
eo board. (See Fig.4)
(5) Disconnect the wire from the connector
Video board. (See Fig.4)
(6) Disconnect the card wire from connector
power supply board. (See Fig.4)
(7) Disconnect the card wire from connector
con board. (See Fig.4)
(8) Remove the tie band and wire protection board fixing the
card wire. (See Fig.4)
(9) Remove the three screws F and screw G attaching the front
panel assembly. (See Fig.4)
REFERENCE :
When attaching the screw G, attach the earth wire with it.
(10) From the bottom side of the main body, remove the four
screws H attaching the front panel assembly. (See Fig.5)
(11) Remove the front panel assembly in the direction of the ar-
row. (See Fig.5)
1-6 (No.MB103)
Wire
protection
CN599 on the DSP
board
Tie
CN415 on the
band
Card
CN206 on the Vid-
wire
CN244 on the S-
Tie
band
CN402 on the
CN400
CN400 on the mi- DSP
board
CN599
Front panel assembly
F
F
CN415 CN206
Audio2 board Video board
Fig.4
Front panel assembly
H
Fig.5
Earth wire
G
F
Tie
band
CN402
Power
supply
board
Tie
band
Micon
board
CN244
S-Video board
H