Standard Timer Recording - Pioneer PRV-9200 Operating Instructions Manual

Recording
• You can go back and reset the start time if you need
to by pressing RETURN.
5 Use the (cursor left/right) to move the
cursor to the recording end time on the grid.
Recording start time
Easy Timer Recording
AM PM
11: 00 12: 00 1: 00
12/13
12/14
12/15
12/13 11:45
MON
CHANNEL + / –
32 REC MODE
As you move the cursor around the grid, an arrow
stretches from the start time to the current cursor
position, representing the length of the recording. A
recording of up to six hours can be set.
6 Press ENTER to set the end time.
7 Select 'Yes' to set the timer recording and exit, or
'No' to go back to the timer recording screen.
• You can check the timer recording details you just set
from the main timer recording screen (see Standard
timer recording below).

Standard timer recording

The timer recording screen you can see all the timer
programs already set, clear programs and set up new
ones.
HOME
MENU
PREV NEXT
1 Press TIMER REC to display the Timer Recording
screen.
You can also access the Timer Recording screen from
the Home Menu (press HOME MENU, select Timer
Recording, then Timer Recording (View)).
Recording end time
2: 00 3: 00 4: 00 5: 00
1:45
AM PM
FINE HDD/DVD HDD
CLEAR
ENTER
TIMER REC
This screen shows all the timer programs currently set.
Timer Recording
Date Start Stop
12/13 MON 7:00 PM 8:00 PM
12/14 TUE 9:00 PM 10:00 PM
New Input
HDD Remain
DVD Remain
• Each row is for one timer recording program, with the
date and time information, channel, recording mode,
DVD or HDD and recording status.
• The amount of free space available on the HDD and
the currently loaded recordable DVD is shown
towards the bottom of the screen.
• In the lower-right corner, the number of timer
programs already set is shown next to Tmr Pgms.
• If there are more than eight timer programs already
set, press NEXT
to switch page (go back using
the PREV button).
• You can also clear a timer program before it's started
(before the recorder enters timer recording standby)
by highlighting it and pressing CLEAR.
2 Select 'New Input' to set a new timer program,
then press ENTER.
Timer Recording
Date Start
12/12 SUN 10 00 AM
Rec to Group
HDD GROUP1
3 Enter the timer recording settings.
Use the (cursor left/right) buttons to select a field;
use the (cursor up/down) buttons to change the
value.
• Date – Choose a date up to one month in advance, or
select a daily or weekly program.
• Start – Set the recording start time.
• Stop – Set the recording end time (maximum length
of a timer recording is 24 hours for HDD recording or
six hours for DVD).
• CH – Choose a channel (2–69 or 1–125 for antenna or
cable channels respectively, excluding skip
channels), or one of the external inputs from which to
record.
CH Mode Rec to Confirm
32 FINE HDD OK
43 FINE HDD OK
10h20m(FINE)
1/1
0h43m(FINE)
Stop CH Rec Mode
-- -- 24 FINE
Program Set
Ttl Name Input
06
49
En