Recording The Results Of Measurement - HEIDENHAIN TNC 620 User Manual

Cycle
427 MEASURE COORDINATE
(2nd soft-key row) Measuring any
coordinate in a selectable axis
430 MEASURE BOLT HOLE CIRCLE
(2nd soft-key row) Measuring
position and diameter of a bolt hole
circle
431 MEASURE PLANE
(2nd soft-key row) Measuring the A
and B axis angles of a plane

Recording the results of measurement

For all cycles in which you automatically measure workpieces (with
the exception of Cycles 0 and 1), you can have the TNC record
the measurement results. In the respective probing cycle you can
define if the TNC is to
Save the measuring log to a file
Interrupt program run and display the measuring log on the
screen
Create no measuring log
If you want to save the measuring log to a file, the TNC, by default,
saves the data as an ASCII file in the directory TNC:\..
Use the HEIDENHAIN data transfer software
TNCRemo if you wish to output the measuring log
over the data interface.
TNC 620 | User's Manual Cycle Programming | 3/2014
Soft key Page
404
407
410
Fundamentals 16.1
16
375