Listening To Your System; Auto Listening Mode; Listening In Surround Sound; Dolby Pro Logic Ii Music Settings - Pioneer XV-DV363 Operating Instructions Manual

HTZ363DVD_EN_WL.book 15 ページ ２００７年２月３日 土曜日 午後３時１３分

Listening to your system

Chapter 3
Listening to your system

Auto listening mode

The Auto listening mode is the simplest way to
listen to any source as it was mastered: the
output from the speakers mirrors the channels
in the source material.
• If you set up the system for Front surround
(page 10), the Front Surround modes will
give the best results.
MCACC TUNE
F.S.SURR SURROUND ADVANCED
• Press SURROUND to select the AUTO
1
listening mode.

Listening in surround sound

You can listen to stereo or multichannel
sources in surround sound.
is generated from stereo sources using one of
the Dolby Pro Logic decoding modes.
• If you set up the system for Front surround
(page 10), the Front Surround modes will
give the best results.
MCACC TUNE
F.S.SURR SURROUND ADVANCED
• Press SURROUND repeatedly to select a
1
listening mode.
The choices that appear in the display will vary
according to the type of source that's playing.
• AUTO – Auto listening mode (see above)
• DOLBY PL (Dolby Pro Logic) – 4.1 channel
surround sound (use with any two-channel
source)
Note
1 If the source is Dolby Digital or DTS, the corresponding indicator lights in the front panel display.
2 Note that when the tuner is selected, multichannel playback is not possible.
• MOVIE (Dolby Pro Logic II Movie) – Pro
• MUSIC (Dolby Pro Logic II Music) – Pro
• STEREO – See Listening in stereo below
TEST TONE
SOUND

Dolby Pro Logic II Music settings

When listening in Dolby Pro Logic II Music
mode, there are three settings you can adjust:
Center Width, Dimension, and Panorama.
1
active, press SOUND.
2
'PANORAMA' then press ENTER to confirm.
2
Surround sound
• C WIDTH (Center Width) – Provides a
TEST TONE • DIMEN. (Dimension) – Adjusts the depth
SOUND
• PANORAMA – Extends the front stereo
Logic II 5.1 channel surround sound,
especially suited to movie sources (use
with any two-channel source)
Logic II 5.1 channel surround sound,
especially suited to music sources (use
with any two-channel source)
With Dolby Pro Logic II Music mode
Use / to select 'C WIDTH', 'DIMEN.' or
better blend of the front speakers by
spreading the center channel between the
front right and left speakers, making it
sound wider (higher settings) or narrower
(lower settings).
of the surround sound balance from front
to back, making the sound more distant
(minus settings), or more forward (positive
settings).
image to include the surround speakers for
a 'wraparound' effect.
03
15
En