Wired Network Setup - Samsung M-202X series User Manual

Wired network setup

You must set up the network protocols on your machine to use it on your
network.
You can use network after connecting network cable to a corresponding port on
your machine.
• For models that do not have the display screen on the control panel, use the
SyncThru™ Web Service or SetIP program.
- See "Using SyncThru™ Web Service" on page 5.
- See "Setting IP address" on page 3.
• For models that have the display screen on the control panel, configure the
network setting by pressing
panel.
4
Printing a network configuration report
You can print Network Configuration Report from the machine's control panel
that will show the current machine's network settings. This will help you to set
up a network.
• The machine has the display screen: Press the
control panel and select Network > Network Config. (Network
Configuration)> Yes.
• The machine does not have the display screen: Press the
Stop/Clear) button for more than five seconds on the control panel.
(Menu) button > Network on the control
(Menu) button on the
(Cancel or
• The machine without the
(WPS) button formore than ten seconds on the control panel.
Using this Network Configuration Report, you can find your machine's MAC
address and IP address.
For example:
• MAC Address: 00:15:99:41:A2:78
• IP Address: 165.254.192.192
5
Setting IP address
• The machine that does not support the network interface, it will notbe
able to use this feature (see "Rear view" on page 15)
• TCP/IPv6 is not supported by this program.
First, you have to set up an IP address for network printing and managements.
In most cases a new IP address will be automatically assigned by a DHCP
(Dynamic Host Configuration Protocol) server located on the network.
IPv4 configuration using SetIP (Windows)
Before using the SetIP program, disable the computer firewall from Control
Panel > Security Center > Windows Firewall.
(Cancel or Stop/Clear) button: Press the
2. Using a network-connected machine
89