Buick Enclave Owner's Manual page 38

Starting the Engine Using
Remote Start
To start the vehicle:
1. Press and release
RKE transmitter.
2. Immediately after completing
Step 1, press and hold
the lamps flash. If the vehicle's
lights cannot be seen, press
and hold for at least
four seconds.
When the vehicle starts, the park
lamps will turn on and remain on as
long as the engine is running. The
doors will be locked and the climate
control system will operate
automatically if the vehicle has the
automatic system, or at the same
setting as when the vehicle was last
turned off.
With an automatic climate control
system and if equipped with heated
seats, the heated seats turn on
during colder outside temperatures
and shut off when the ignition is
turned on. See Heated and
Ventilated Front Seats 0 68.
The rear window defogger and
heated mirrors, if equipped, turn on
during colder outside temperatures
and turn off when the ignition is
turned on.
on the
After entering the vehicle during a
remote start, press the brake and
ENGINE START/STOP with the
until
transmitter in the vehicle to drive the
vehicle.
If the vehicle is left running, it
automatically shuts off after
10 minutes unless a time extension
has been done.
Extending Engine Run Time
To extend the engine run time by
10 minutes, repeat Steps 1 and 2
while the engine is still running. An
extension can be requested
30 seconds after starting. The
engine run time can only be
extended if it is the first remote start
since the vehicle has been driven.
Remote start can be extended
one time.
Keys, Doors, and Windows
If the remote start procedure is used
again while the engine is still
running, 10 minutes will be added
on for a total of 20 minutes.
For example, if
pressed again while the engine is
still running, 10 minutes will be
added on for a total of 20 minutes .
A maximum of two remote starts or
remote start with an extension are
allowed between ignition cycles.
After the vehicle's engine has been
started two times using the remote
start button or a start with an
extension, the ignition must be
turned on and then back off before
the remote start procedure can be
used again.
Canceling a Remote Start
To manually shut off a remote start:
Press and hold
lamps turn off.
Turn on the hazard warning
flashers.
Turn the ignition switch on and
then off.
37
and then are
until the