Displayed Messages - Pioneer AS-LX70 Operating Instructions Manual

10 Additional information

Displayed Messages

Message
192kHz PCM
SACD
DTS-HD
DTS Express
Dolby TrueHD
Dolby D+
No MIC
Muting
2ch Only
Exit
HDMI Through
Unknown
No Genre
HDMI C.ERR 2C*
Can't use
HDMI C.ERR 1**
Noisy!
Error MIC!
Error Speaker!
Over Temp
OC Error1
OC Error2
*** BackUpERR
46
En
Description
These messages are displayed when you operate a function incompatible with the audio
source being played back.
Displays when you press MCACC when the MCACC setup mic is not connected.
Displays when you press TEST TONE or MCACC while this unit is muted.
An operation is prohibited because it is only applicable to 2 channel sources, while the
current source is a multichannel source.
Appears when a menu is automatically exited after a set period of inactivity.
Displays when you change the Listening Mode, the volume level, or some sound settings
when the HDMI Mode is set to Through Mode.
The genre information for contents being played back on the HDD/DVD recorder cannot be
obtained.
There is no genre set for contents being played back on the HDD/DVD recorder.
The connected component is not compatible with synchronized genre mode.
• You tried to use Genre Sync Mode for a source component that does not support this
function.
• The source component is in a situation where Genre Sync Mode cannot be used.
• You tried to use Genre Sync Mode when the input source of this unit is a source other than
HDMI.
• The operation is forbidden due to the surround settings.
• When the volume level is over 51, some functions are restricted.
Check if the HDMI cable is properly connected. If the cable is properly connected, this unit
may be damaged. In such an event, please contact a Pioneer-authorized service center or
your nearest dealer.
Background noise is too high to complete MCACC setup successfully.
An error occurred during MCACC setup because the microphone is not connected or is not
connected properly.
An error occurred during MCACC setup because the speakers are not connected or are not
connected properly.
Try lowering the volume. If this problem is not fixed by removing and inserting the power
cable, this unit may be damaged. In such an event, please contact a Pioneer-authorized
service center or your nearest dealer.
Check whether the speaker cables are short-circuited. If the error message continues to be
displayed, contact your Pioneer authorized service center or your dealer for servicing.
Contact your Pioneer authorized service center or your dealer for servicing.