Pioneer AS-LX70 Operating Instructions Manual page 11

Connecting up
1 Connect the display unit to the receiver subwoofer.
Plug the display cable into the connector on the rear of
the display unit, then plug the other end of the display
cable into SYSTEM connector on the receiver subwoofer.
Caution
• Do not attempt to attach the display unit to the wall.
2 Assemble the AM loop antenna.
a b
a. Bend the stand in the direction indicated by the arrow.
b. Clip the loop onto the stand.
c. If you want to fix to a wall or other surface, perform
step b after first securing the stand with screws.
It is recommended that you determine the reception
strength before securing the stand with the screws.
3 Connect the AM and FM antennas
a. Connect one wire of the AM loop antenna to each AM
2
antenna terminal .
For each terminal, press down on the tab to open;
insert the wire, then release to secure.
2
3
b. Push the FM antenna plug onto the center pin of the
FM antenna socket.
Note
1 • Keep antenna cables away from other cables, the display unit and receiver subwoofer.
• If reception with the supplied antenna is poor, see Improving poor FM reception and Improving poor AM sound on page 28 or Connecting
external antennas on page 35.
• Do not attach any antenna other than the provided loop antenna, or an external antenna as described on page 35.
2 • Don't let it come into contact with metal objects and avoid placing near computers, television sets or other electrical appliances.
• If radio reception is poor, you may be able improve it by re-inserting each antenna wire into the opposite terminal.
• For best reception, do not untwist the AM loop antenna wires or wrap them around the loop antenna.
3 To ensure optimum reception, make sure the FM antenna is fully extended and not coiled or hanging at the rear of the unit.
c
1
.
3
1
4 Connect each speaker.
• Each speaker cable has a color-coded connector at
one end and two wires at the other end.
• Twist and pull off the protective shields on each wire.
• Connect the wires to the speaker. Each speaker in the
illustration can be identified by means of the color-
coded indicator provided on the rear-surface model
label. Match the color-coded wire with the color
indicator on the model label, then insert the color-
coded wire into the red (+) side and the other wire
into the black (–) side.
Black (–) Red (+)
• Connect the other end to the color-coded speaker
terminals on the side of the receiver subwoofer. Make
sure to insert completely.
Be careful when inserting the speaker plug, as it
must be inserted in the proper direction when being
plugged into one of the terminals. Please make sure
to connect correctly.
Color-coded wire
(Connect to speaker)
Color-coded connector
(Connect to receiver subwoofer)
Color-coded wire
02
11
En