3
2
1
,I HQJLQH GRHVQ¶W VWDUW
If you did not move the Master Control
lever to warm start Q quickly enough
after the engine began to fire, the
combustion chamber has flooded.
•
Set Master Control lever to O.
•
Turn the twist lock above the
rear handle 90° counterclockwise
(lower illustration).
•
Lift off the carburetor box cover
vertically.
•
Clean away loose dirt from around
filter.
•
Pull off the spark plug boot.
•
Take out screw and remove the
shroud.
•
Unscrew and dry off the spark plug.
•
Set the Master Control lever to G .
•
Crank the engine several times
with the starter
to clear the combustion chamber.
•
Refit the spark plug and connect
the spark plug boot -
reassemble all other parts.
•
Set Master Control lever
to warm start Q
even if engine is cold.
•
Now start the engine.
)XHO WDQN UXQ XQWLO GU\ DQG WKHQ
UHIXHOHG
•
Pull starter rope several times to
prime the fuel system.
&KHFNLQJ &KDLQ /XEULFDWLRQ
The saw chain must always throw off
a small amount of oil.
•
Never operate your saw without
chain lubrication. If the chain is run
dry the whole cutting attachment
will be irretrievably damaged within
a very short time.
Always check chain lubrication and
oil level in tank before starting work.
•
Every new chain has to be broken
in for about 2 to 3 minutes.
•
After breaking in chain, check chain
tension and adjust if necessary -
see "Checking Chain Tension".
46