Advertisement
8
IMMOBILIZER INTERFACE ANTENNA RING MOUNTING
1. Locate the 2 phillips screws at the steering column
that secure the upper steering column shroud to the
steering column assembly. Refer to FIGURE U for
location reference.
2. Using a phillips screwdriver, loosen but do not
remove the 2 phillips screws. (FIGURE V)
3. Locate the illuminated ignition cylinder ring and
gently slip the immobilizer interface antenna ring
behind the illuminated ring and behind the upper
steering column shroud. Re-secure the previously
loosened phillips screws securing the upper steering
column shroud to the steering column assembly.
(FIGURE W)
4. Route the immobilizer interface antenna ring wiring
to the left side of the steering column and down the
steering column and plug into the 2-pin port on the
immobilizer interface (refer back to FIGURE T).
Secure the immobilizer interface antenna ring wiring
to the existing vehicle wiring and remote start
harness using 2 of the supplied 5" tie wraps. Be
sure to route wiring to avoid the lower steering
column shroud screw hole and any steering column
moving parts. (FIGURE X)
PART NUMBER
H001SXA000
ISSUE
DATE
01
03/14/06
FIGURE U
FIGURE V
SUBARU OF AMERICA
FIGURE W
FIGURE X
7 OF 10
Advertisement
