Table of Contents
Advertisement
VI-1. LNB Setting
The Low Noise Blockdown Converter (LNB) amplifies the signal received by
the satellite dish and lowers the frequency of the signal. The signal is then fed from
the LNB at the dish via cable to the PVR.
For the LNB Settings, move the cursor to Installation item and press
Then, move the cursor to the LNB Setting item and press
A. Satellite Name
Press the
button to display the Satellite List. The Satellite name list is put in
alphabetical order. Select one of the preprogrammed satellites that correspond to the
value of the antenna. If the desired satellite name is not in the list, then select
B. Tuner Select
Select a tuner for channel searching from the selected satellite.
C. Connection Type
If two tuners share one LNB as the diagram 2-2) on page 12, select Loop Through.
If a service is being recoded, the other tuner can receive only the signal of the same band
and polarity as being recorded in this configuration.
If the tuners are connected to separated LNBs (or Dual LNB), select
There is no restriction as in the Loop Through configuration.
D. LNB Frequency
Select the L.O. Frequency set to antenna. The LNB Frequency of 5150, 9750,
10600, 10750, 11475 MHz or Universal can be selected by using the
00% Level
00% Quality
button.
34
button.
Others.
Separated.
or
button.
Advertisement
Table of Contents
