Authentication/Authorization For Ssh/Telnet Users By A Radius Server - HP 12500 Series Configuration Manual

Verifying the configuration
Telnet to the switch as a user and enter the username hello@bbb and the correct password. You pass
authentication and log in to the switch. Issuing the display connection command on the switch, you can
see information about the user connection.
Authentication/authorization for SSH/Telnet users by a
RADIUS server
NOTE:
The configuration of authentication and authorization for SSH users is similar to that for Telnet users. The
following example describes the configuration for SSH users.
Network requirements
As shown in
authorization, and to include the domain name in the username sent to the RADIUS server.
Configure IMC to act as the RADIUS server, add an account with the username hello@bbb on the
RADIUS server, and configure the RADIUS server to assign the privilege level of 3 to the user after the
user passes authentication.
Set the shared keys for RADIUS communication to expert.
Figure 12 Network diagram
Configuration procedure
Configure the RADIUS server (when the server runs on IMC PLAT 5.1 SP1)
1.
NOTE:
This section assumes that the RADIUS server runs on IMC PLAT 5.1 SP1 (E0202P05) and IMC UAM 5.1
SP1 (E0301P03).
# Add an access device.
Log in to IMC, click the Service tab, and select User Access Manager > Access Device
Management > Access Device from the navigation tree. Then, click Add to configure an access
device as follows:
Set the shared key for secure authentication to expert.
a.
Set the ports for authentication to 1812.
b.
Figure 12, configure the switch to use the RADIUS server for SSH user authentication and
54