Pioneer DVR-540H-S Operating Instructions Manual page 43

Recording
also Deleting a timer program on
page 44.
2 Select 'New Input' to set a new timer
program, then press ENTER.
Timer Program Set
Manhattan Open Tennis
CH Date Start Stop
10ch EVERYDAY 6:00PM 7:00PM
Detailed Settings
Enter Details
Record To HDD
Recording Mode XP
Auto Replace Rec. On
Genre No Category
Dual Mono Recording L
HDD Recording Format Video Mode On
3 Enter the timer recording settings.
Use the buttons to select a field; use
the buttons to change the value.
• CH – Choose a channel (2 to 69 for
antenna channels; 1 to 125 for cable,
excluding skip channels), or one of the
external inputs from which to record.
• Date – Choose a date up to one month in
advance, or select a daily or weekly
program.
• Start – Set the recording start time.
• Stop – Set the recording end time
(maximum length of a timer recording is
24 hours).
• Extend – Extend the end time of the
timer recording (select Off, 30, 60, 90 or
120 mins).
4 If you want to change the recording
mode, recording destination, etc., select
'Set Detailed'.
In this area you can set:
Record to – Select HDD for hard disk
recording or DVD for DVD recording. Select
HDD for Auto Replace Recording (daily or
weekly timer recording only).
Extend
30 min
Store Program
Set Detailed
Set Title Name
Cancel
Recording Mode – Select XP, SP, LP, EP,
SLP or SEP, (See Setting the picture quality/
recording time on page 37). If Manual
Recording is on, then you can also select the
LPCM setting, or MN (press ENTER then use
the buttons to select the level).
Auto Replace Rec. – automatically erases
the previous daily or weekly recording when
the next one is recorded.
Genre – Select a record genre (for HDD
recording only).
Dual Mono Recording – Select which
channel of a dual mono broadcast to record
(necessary if recording to a Video mode
DVD).
HDD Recording Format – Select Video
Mode On or Video Mode Off depending on
whether you need high-speed copying to
Video mode DVD capability or not.
5 After entering all the timer recording
information, highlight 'Store Program'
and press ENTER.
The timer recording list screen is displayed
again. The timer program you just input
appears in the list. The rightmost column
shows various timer recording status
messages:
• OK – Can be recorded.
• Time Over – Not enough space on the
HDD (the recording won't finish).
• Over 12h – Recording time of over 12
hours set (when recording to the HDD
the recording will be split into two titles).
• Overlap – Two timer programs partially
or completely overlap. The one starting
earlier will take priority.
• Until ... (e.g., Until 8/13) – For a regular
recording, the last program that could
be recorded is shown.
• Data Over –Can't record because the
disc management area of the disc is full.
05
43
En