Pioneer DVR-540H-S Operating Instructions Manual page 129

Additional information
Message
• This content is copy protected.
• Incorrect CPRM information.
• Repairing disc.
• Repairing the HDD.
• Could not repair the disc.
• Overheating has stopped operation.
Press DISPLAY to clear this message.
• HDD optimization is recommended.
This can be done using Disc Setup.
• Please perform HDD optimization.
This can be done using Disc Setup.
• The HDD has not been sufficiently
optimized. Please optimize again.
Searching for printer. Please wait a
moment.
The printer is not ready or there is no
printer connected. Please check the
printer status.
Explanation/Action
The video source is copy-protected and cannot be
recorded.
The recorder could not read the CPRM
information. The recorder may be damaged—
please consult a Pioneer Service Center.
During recording, the power was cut. This display
appears when the power is restored.
The recorder was unable to repair the disc after a
power cut. The contents of the recording will be
lost.
The internal temperature of the recorder has
exceeded the operating limit. If this message
reappears, please contact a Pioneer authorized
service center.
The HDD should be optimized (basically, HDD
housekeeping) to maintain playback and recording
performance.
The HDD is in more urgent need of optimization in
order to maintain performance.
If this message appears repeatedly after
optimizing the HDD it is likely that there is not
enough free space on the HDD for optimization to
complete properly. Please erase some titles from
the HDD and optimize again.
This message is displayed when the recorder is
scanning for a connected printer, or when the
printer is not yet ready for printing. If there is no
printer connected, please connect one.
This message is displayed when communication
could not be established with the printer. See the
Troubleshooting section if you do not know the
cause.
15
129
En