SRAM Guide DB5 Service Manual page 29

Hold the banjo fitting at the desired angle. Use a torque wrench
8
with an 8 mm flare nut crowfoot to tighten the banjo bolt to
9.7-11.7 N·m (86-104 in-lb).
9 Insert the bleed block into the caliper.
You must bleed your brakes before reinstalling the brake pads.
10 Spray isopropyl alcohol on the caliper and clean it with a rag.
Visually check your work. If any of the o-rings protrude from the banjo fitting or banjo bolt, remove and replace the o-rings, then repeat
the installation process.
Servicing your brakes removes all of the fluid from the system. You must bleed the brakes after you service the brake caliper and/or lever.
For brake bleed, brake hose shortening, and brake pad replacement instructions,
N O T I C E
8 mm
Bleed block
⚠ CAUTION
visit www.sram.com/service.
9.7-11.7 N•m (86-104 in-lb)
Caliper Piston Installation
22 mm
29