Installing The Processor; Installing The Memory Modules - Intel D845GERG2 Quick Reference

3 Installing the Processor

To install the processor, follow these steps:
1. Observe the precautions in "Before You Begin" on page 3.
2. Lift the processor socket lever.
3. Install the processor so that the corner with the triangle marking (A) is
aligned with the corner where the lever is attached to the socket.
4. Lower the lever back to its original position.
5. The desktop board has an integrated processor fan heat sink retention
mechanism (RM). For instructions on how to install the processor fan heat
sink, refer to the boxed processor manual or the Intel World Wide Web
site at:
http://support.intel.com/support/processors/pentium4/intnotes478.htm

4 Installing the Memory Modules

CAUTION
Install memory in the DIMM sockets prior to installing the AGP video card
to avoid interference with the memory retention mechanism.
The two DIMM sockets are arranged as DIMM 0 and DIMM 1, as shown in the
following figure. If installing a single DIMM, install it in DIMM 0.
To install DIMMs, follow these steps:
1. Remove the AGP video card if it interferes with the DIMM clips from
being easily opened and closed.
2. Align the small notch in the bottom edge of the DIMM with the key in the
socket.
8 Intel Desktop Boards D845GERG2 and D845GEBV2
A
Quick Reference
OM12078