Desktop Boards D845GERG2 and D845GEBV2 have an integrated AGP card
retention mechanism (RM).
Follow these instructions to install an AGP card:
1.
Place the AGP card in the AGP connector.
2.
Press down on the card until it is completely seated in the connector and the
card retention notch snaps into place below the RM.
3.
Secure the card's metal bracket to the chassis back panel with a screw.
Install PCI cards into the PCI bus add-in card connectors on the desktop board.
To remove the AGP card, reverse steps taken when installing an AGP card.
Before removing the card, make sure to push back on the RM lever (A) until the
retention pin completely clears the notch in the card.
10
Intel Desktop Boards D845GERG2 and D845GEBV2
A
OM14695
Quick Reference