Lenovo ThinkStation P510 Hardware Maintenance Manual page 121

6. Note the orientation of the new card reader and route the card reader cable into the cable clip. Hold
the clip on the card-reader retaining bracket. Then, insert the new card reader into the card-reader
slot in flex module until it snaps into position.
Figure 38. Installing the card reader in the flex module
7. Position the flex module cover on the flex module. Ensure that the rail guides on the bottom of the flex
module cover engage the rails on the flex module. Then, push the cover to the front of the flex module
until it snaps into position.
Figure 39. Reinstalling the flex module cover
8. Connect the card reader cable to the USB 2.0 connector or card reader connector on the system board.
See "Parts on the system board" on page 35.
What to do next:
• To work with another piece of hardware, go to the appropriate section.
• To complete the installation or replacement, go to "Completing the parts replacement" on page 189.
eSATA connector or IEEE 1394 connector
To install or replace an eSATA connector or IEEE 1394 connector in the flex module, do the following:
1. Prepare your computer. See "Preparing your computer and removing the computer cover" on page 99.
2. Remove the flex module out of the front of the computer. See "Device in the optical-drive bay" on
page 102.
.
Chapter 9 Installing or replacing hardware
115