Ead Fast Deployment Configuration Example (1); Network Requirements; Configuration Procedure - HP 6600 Security Configuration Manual

EAD fast deployment configuration example (1)

Network requirements

As shown in
3/0/1 of Router, and they use DHCP to obtain IP addresses.
Deploy EAD solution for the intranet so that all hosts must pass 802.1X authentication to access the
network.
To allow all intranet users to install and update 802.1X client program from a web server, configure the
following:
Allow unauthenticated users to access the segment of 192.168.2.0/24, and to obtain IP address on
•
the segment of 192.168.1.0/24 through DHCP.
Redirect unauthenticated users to a preconfigured web page when the users use a web browser to
•
access any external network except 192.168.2.0/24. The web page allows users to download the
802.1X client program.
Allow authenticated 802.1X users to access the network.
•
Figure 40 Network diagram
In addition to the configuration on the Router, complete the following tasks:
Configure the DHCP server so that the host can obtain an IP address on the segment of
•
192.168.1.0/24.
• Configure the web server so that users can log in to the web page to download 802.1X clients.
Configure the authentication server to provide authentication, authorization, and accounting
•
services.

Configuration procedure

1. Configure an IP address for each interface. (Details not shown.)
Figure 40, the hosts on the intranet 192.168.1.0/24 are attached to port GigabitEthernet
108