Pioneer DV-696AV-S Operating Instructions Manual page 55

Additional information
Problem
New settings made in the
Setup screen menus while
a disc is playing are
ineffective.
Settings are canceled.
The remote control
doesn't seem to work.
No picture/No color.
Screen is stretched or
aspect does not change.
Picture disturbance
during playback or the
picture is dark.
Remedy
• Some settings can be changed while a disc is playing, but are not
effective until the disc is stopped then restarted: Press
playback again ( ).
• When the power is cut due to power failure or by unplugging the
power cord, settings will be canceled: Press
front panel to turn the player off. Wait for --OFF-- to disappear from
the display, then unplug the power cord.
• The remote control is too far from the player, or the angle with the
remote sensor is too wide: Use the remote within its operating range
(page 19).
• The batteries are exhausted: Put in new ones (page 6).
• Incorrect video connections: Check that connections are correct
and that plugs are inserted fully. Also check the video cable for
damage.
• TV/monitor or AV amplifier settings are incorrect: Check the
instruction manual of the connected equipment.
• The video output is set to progressive but your TV/monitor is not
compatible with progressive scan: See page 14 for how to set to
interlace.
• The TV Screen setting in the Initial Settings menu is incorrect. See
page 52 for how to set it correctly for your TV/monitor.
• This player is compatible with Macro-Vision System copy guard.
Some discs include a copy prevention signal, and when this type of
disc is played back, stripes etc., may appear on some sections of the
picture depending on the TV. This is not a malfunction.
• Due to the player's copy protection circuits, connection of this
device through a VCR or an AV selector may prevent recording or
cause picture problems. This is not a malfunction.
, then start
STANDBY/ON on the
08
55
En