Rear Panel - Pioneer DV-525 Operating Instructions Manual

Rear Panel

1
DIGITAL OUT
OPT.
(The TV SYSTEM switch and AC IN power cord connection
terminal are not present on U.S. and Canadian models)
1
DIGITAL OUT jacks (coaxial, optical (OPT.))
Use to output the digital audio signal recorded on
discs. You can output the digital signal via either
coaxial or optical output jack to an AV amplifier or
receiver (page 16).
2
CONTROL IN jack
Use to connect this player to another component
bearing the Pioneer Î mark. This lets you control
this unit as though it were a component in a system.
Player operations are then performed by pointing the
remote control at the component that the player is
connect to (page 18).
3
TV SYSTEM switch
Use to change the TV signal mode to either PAL or
NTSC according to the type of TV and disc to be
used. When the switch is in the AUTO position, the
player outputs the format on the disc as is (page 18).
(The TV SYSTEM switch is not present on U.S. and
Canadian models.)
4
VIDEO OUT SELECT switch
Use to set which output is used to output the video
signals. Select either video/S-video or component
video signal output depending on the connections
you make (page 17).
5
VIDEO OUT jack
Connect to the video input on a TV or monitor or AV
amplifier or receiver with video input capability.
When using this output, be sure to set VIDEO OUT
SELECT to the left position (pages 15 and 17).
12
2 3 4 5 6
VIDEO OUT S-VIDEO OUT
CONTROL TV SYSTEM VIDEO
OUT
IN
SELECT
PAL
NTSC AUTO
7 8
COMPONENT
VIDEO OUT
Y
P AUDIO OUT
B
R
P
R
6
S-VIDEO OUT jack
If your TV or monitor has an S-video input, clear
picture reproduction is possible by connecting the
player to your TV or monitor via the S-Video jack.
When using this output, be sure to set VIDEO OUT
SELECT to the left position (page 17).
7
COMPONENT VIDEO OUT jacks
If your projection monitor, projector or similar
component has component video inputs, you can
produce a higher quality picture on your projection
monitor or projector by connecting to the component
video outputs on this unit. When using these jacks,
be sure to set VIDEO OUT SELECT to the right
position (page 17).
8
AUDIO OUT jacks
Use to output two-channel audio (analog) to the
audio stereo inputs on a TV or stereo amplifier. If you
are connecting to a receiver that has both digital and
analog input jacks for DVD player connection, it may
be beneficial to make both connections (pages 15
and 16).
9
AC IN power cord connection terminal
Use to connect the power cord to the wall outlet
(page 15). (The AC power cord of the U.S. and
Canadian models is built into the player.)
9
AC IN
L