Hitachi CP-X980W Service Manual page 27

The ECN1/ECN2 wires shall be laid so that
the excess wires shall be laid out as shown
in the figure below.
ECN1
ECN2
Terminal
board
ECN1
EDI2
The installation of the flexible cable shall be subject to
the drawing in the bottom right corner of this sheet.
There shall be no slack in the wire
in this area. The excess wire shall
The installation of the flexible cable
be folded and tucked under
shall be subject to the drawing in the
(which will prevent the wire from
bottom right corner of this sheet.
getting tangled in the upper cover).
The ECN3 shall be connected to
CNFZ
the EMD1 prior to securing the PWB
DRIVE. In addition, the installation of
the flexible cable shall be subject to
the drawing in the bottom right corner
of this sheet.
Fan cover
POWER UNIT (BALLAST)
PAS6
Purse lock 8
The connectors for the ballast and
power fan shall be clamped to the
fan cover with a purse lock.
Screw
PWB DRIVE
Washer
PWB DRIVE
The CNSG shall be secured to
PWB RGB
the PWB DRIVE with a screw.
Particular care shall be taken
not to bend the wires when
laying out them.
CNDS2
ECN2
EDS2
EDI1
ESW1
It shall be securely fitted
Flexible cable
to PWB FAN G01.
ERM1
(R panel)
EDI3
EPRX
Flexible cable
EPGX
(G panel)
EPBX
Particular care shall be taken to
prevent the wire stopper from being
twisted on the board.
Flexible cable
(B panel)
PWB DRIVE
EMD1
ECN3
Push the slack in the ECN3
cable between the ballast
and PWB DRIVE.
POWER UNIT
(BALLAST)
EMD1
PWB DRIVE
ECN3
Particular care shall be taken to prevent
CNSG
the CNSG/CNDS2 from getting entangled
in the upper cover when mounting the cover.
The excess CNSG wire shall be tucked
under the PWB DRIVE.
CNSG
CNSW
PAS3
Wire clamp
SP.L
SP.R
CNRM
SP.R/SP.L
LSW2
LSW1
ETEM
Wiring for PWB DRIVE Mounting
Upper cover
ESW2
PWB R/C
PWB KEYBOARD
The wire clamp shall be secured with a wire stopper
to prevent it from moving.
PWB TEMP
The installation of the flexible cable shall be subject to the
drawing shown below.
(1) Insert the flexible flat cable
securely into the connector
base. (Particular attention
shall be paid to the inserting
2
direction as this connector
1
has contacts on its underside).
(2) Move the hinge in the arrow
Flexible flat cable
direction to securely lock it.
Connector base