Hitachi CP-X980W Service Manual page 24

PWB VIDEO
The CNPOW lead wire shall not run directly
over the rib but shall be laid so that it runs
around the rib and passes it on its left-hand
side. In addition, the height of the lead wire
shall not exceed that of the rib.
FAN (Power)
CN1B
CN101
CN101
Those parts shall be pulled out
and left on the outside until the
optical unit is mounted.
CNDS1
CNDS2 CNSG
The wire shall be laid
so that it passes the
ESD2
rib on its left-hand side.
ESD1
The SK binder screw (SK1)
There shall be no slack in the wire.
shall be tightened so that
the excess binder is located
on the backside.
EPOW
The wire between the POWER
UNIT (CIRCUIT) and PWB FILTER
shall be secured by hanging it on
CNPOW
the hook of the bottom case.
There shall be no slack
CN102
in the wire.
POWER UNIT (CIRCUIT)
PWB FILTER
Speaker (R)
CN1A
SP.R
PWB R/C
CNRM
LSW2
SP.L
Taping (TAPE1)
The LSW2 wire shall be
Taping (TAPE4)
secured by means of
Speaker L shall be secured in such a way that there is no
taping in the vicinity of
space between the tape/wire and the surface of the board.
the screw rib.
The wire shall be laid so that it is located under the screw boss.
The wire shall be laid so that there shall be no slack, and then
secured.
The adhesive tape shall be placed directly on the left-hand side
of the screw boss and the top of the adhesive tape shall be
aligned to that of the screw boss as shown in the figure at the
right (which will prevent the wire from getting tangled in the
optical unit when mounting it).
Taping (TAPE3)
Speaker L shall be secured in such a way that there is no space between the tape/wire and
the surface of the board. The adhesive tape shall be placed from the center of the speaker
(which will prevent the wire from getting tangled in the optical unit when mounting it).
Top
Speaker (L)
Top
Those parts shall be pulled out
and left on the outside until the
optical unit is mounted.
Screw boss
TAPE4
The wire shall be laid so that the distance between
the lower edge of the boss and the wire shall be
5mm or less (the bottom case line shall be used as a reference).
Wiring for Set's Bottom Panel
Bottom
case line