Hitachi CP-X980W Service Manual page 25

Sirocco fan (for the panel)
The wire shall be laid so that the
connector for focus/zoom motor
would not get tangled in the gear.
Focus/zoom motor
Sirocco fan (for the panel)
#8051
#852
CNSEN
The wire shall be laid so that
it passes through the notch.
The PWB SENSOR and connector
CNSEN shall be mounted on the front duct
cover prior to mounting the optical
engine.
Front duct cover
PWB SENSOR
Junction board for connector
CNFZ #8061
EZF1
PAS4
Purse lock 8
PAS5
Purse lock 8
CN101
CN101
Front duct cover Vertical (side) lamp fan
CNDS1 CNDS2
POWER UNIT (CIRCUIT)
#581
The wire shall be laid so
that it passes through the
inside of the mounting
bracket for fan.
CNSG
PWB R/C
CNRM
LSW2
SP.L
PH connector
Junction connector
LSW1
(connected to LSW2)
Lamp fan
Lamp SW (LSW1)
Wiring for Optical Unit Mounting
Particular care shall be
taken to prevent the wire
from getting entangled in the
switch lever (LSW1)