Mitsubishi Electric FR-E720-0.1K Instruction Manual page 18

(2) Total wiring length
The overall wiring length for connection of a single motor or multiple motors should be within the value in the table below.
Cable Pr. 72 Setting
Type (carrier frequency)
1 (1kHz) or lower
Unshielded
cable
2 (2kHz) or higher
1 (1kHz) or lower
Shielded
cable
2 (2kHz) or higher
When driving a 400V class motor by the inverter, surge voltages attributable to the wiring constants may occur at the
motor terminals, deteriorating the insulation of the motor. Take the following measures 1) or 2) in this case.
1) Use a "400V class inverter-driven insulation-enhanced motor" and set frequency in Pr. 72 PWM frequency selection
according to wiring length.
Carrier frequency
2) Connect the surge voltage suppression filter (FR-ASF-H/FR-BMF-H) on the inverter output side.
NOTE
 Especially for long-distance wiring, the inverter may be affected by a charging current caused by the stray
capacitances of the wiring, leading to a malfunction of the overcurrent protective function, fast response current limit
function, or stall prevention function or a malfunction or fault of the equipment connected on the inverter output side.
If malfunction of fast-response current limit function occurs, disable this function. If malfunction of stall prevention
function occurs, increase the stall level. (
operation selection in Chapter 4 of the FR-E700 Instruction Manual (Applied))
 When using the automatic restart after instantaneous power failure function with the wiring length exceeding 100m,
select without frequency search (Pr. 162 = "1, 11"). (
Voltage
0.1K 0.2K
Class
200V class 200m 200m
400V class - -
200V class 30m 100m
400V class - -
200V class 50m 50m
400V class - -
200V class 10m 25m
400V class - -
Wiring Length
50m or less 50m to 100m
14.5kHz or less 8kHz or less
Refer to Pr. 22 Stall prevention operation level and Pr. 156 Stall prevention
0.4K 0.75K 1.5K
300m 500m 500m
200m 200m 300m
200m 300m 500m
30m 100m 200m
75m 100m 100m
50m 50m 75m
50m 75m 100m
10m 25m 50m
Exceeding 100m
2kHz or less
Refer to Chapter 4 of the FR-E700 Instruction Manual (Applied))
Wiring
3.7K
2.2K
or Higher
500m 500m
500m 500m
500m 500m
300m 500m
100m 100m
100m 100m
100m 100m
75m 100m
2
14