Setting The Clock - Sangean DT-250 Manual

Setting the Clock

This radio features a clock that will display the current time while radio
is off.
To set the clock:
1. Turn radio off.
2. P ress and hold MEMO/CLOCK button until the hour setting begins
blinking and the colon is no longer blinking.
3. Select hour by pressing the Tuning Controls ( UP/Down ) button
until desired hour is displayed.
4. Press MEMO/CLOCK button again to set the minutes.
5. The minute indicators should now be blinking. Using the Tuning
Control buttons ( UP/Down ) until desired minutes is displayed.
6. Press MEMO/CLOCK button again to complete time setting.
7. Time should display solidly with the colon blinking periodically.
AM tuning step
For Northern American countries and some South American countries,
AM tuning step is 10 kHz. On other countries is 9 kHz, To change AM
band tuning step, please follow below steps.
1. Change the AM band tuning step from 9 kHz to 10 kHz. When ra-
dio is off, continuously press Tuning control UP button then power
on/off button for more than 3 seconds until display shows 520 kHz
indicating AM step has been changed to 10 kHz tuning step.
2.  C hange the AM band tuning step from 10 kHz to 9 kHz When radio
is off, continuously press Tuning Control DOWN button then power
on/off button for more than 3 seconds until display shows 522 kHz
indicating AM step has been changed to 9 kHz step.
7