Sangean DT-120 User Manual
  1. Manuals
  2. Brands
  3. Sangean Manuals
  4. Radio
  5. DT-120
  6. User manual

Sangean DT-120 User Manual

Hide thumbs Also See for DT-120:

Advertisement

Table of Contents

See also: Service Manual , Operating Instructions
DT-120/DT-180
GB
Revision 1

Advertisement

Table of Contents
loading

Related Manuals for Sangean DT-120

Summary of Contents for Sangean DT-120

  • Page 1 DT-120/DT-180 Revision 1...
  • Page 3 Controls POWER / BAND button LCD display DBB/● STEP button Mono/Stereo button/Time setting button Tuning up/down button Volume button Lock switch Battery compartment Strap holder Earphone jack Memory button Display Selected band Battery power indicator Signal level indicator FM stereo indicator 90 minutes auto shut off Memory presets Key lock function...

  • Page 4: Battery Installation

    Battery Installation Battery cover is located on the back of the unit. Slide the cover downwards to gain access to the battery compartment. Insert two AAA (UM-4) batteries into the compartment. Make sure that the battery is positioned in accordance with the indicated diagram. Replace cover.

  • Page 5: Volume Control

    Use the volume control to adjust volume level. Display will show the changes when you operate the volume control. Tuning the radio Band Frequency DT-120 522-1710 kHz (9kHz) Antenna DT-120 520-1710 kHz (10kHz) Internal/rotate radio for best reception Band Frequency 87.50-108 MHz...

  • Page 6: Scan Tuning

    90 Minutes auto shut off device For saving battery power, this radio is designed to auto shut off after 90 minutes operation, LCD display shows For continuous listening if necessary, pressing POWER/BAND button for more than 2 seconds to turn on the radio. Scan Tuning Turn on the radio, select required band by pressing POWER/BAND button.
  • Page 7 Memory Tuning (Station preset) Turn on the radio by pressing and holding POWER/ BAND button. Select required band by pressing POWER/ BAND button. Tune to the desired station using the Scan or Manual tuning steps described above. When the desired station is reached, press and hold Memory button (1-5) for more than 2 seconds until display M x stops flashing followed with a beep (via earphone).

  • Page 8: Software Version

    DBB (Dynamic Bass Boost) Press and release DBB/● STEP button to activate the Deep Bass Boost function to have stronger bass sound, display will appear DBB symbol. Press again will cancel the DBB. Note: Suggest to activate the DBB when using earphones. Software version The software display cannot be altered and is just for your reference.

  • Page 9: Key Lock Function

    Key Lock Function The key lock function is used to prevent unintentional operation of the radio. Key lock switch is located on the rear of the radio. When the key lock is set to LOCK, every button will be disabled and a key lock icon will appear on the screen.

  • Page 10: Specification

    Specification Battery: 2 X AAA (LR03, UM-4) Frequency Coverage: FM: 87.50-108 MHz 522-1710 kHz (DT-120 9kHz) 520-1710 kHz (DT-120 10kHz) Output Power: 1.0 mW+ 1.0 mW Earphone Jack: 3.5 mm diameter (stereo) The company reserves the right to amend the specifications without notice.

This manual is also suitable for:

Dt-180

Table of Contents