Battery Installation; Tuning The Radio - Sangean DT-250 Manual

Battery Installation

1. Open the battery cover located on the radio of your radio by sliding
in the direction shown by the arrows.
2. Insert two AA ( UM-3 ) size batteries, one in each compartment.
Close the battery cover.
3. A flashing " E " appearing on the LCD display indicates a weak bat-
tery and that replacement of batteries is required.
4. Turn the radio off and replace the batteries within three minutes to
avoid reset presets and clock setting during battery replacement.

Tuning the radio

Antenna
The lead connecting earphones to your radio acts as an FM antenna
when plugged into the headphone jack. The lead should be extended
as much as possible to increase FM reception. There is a separate
directional antenna built into the radio for AM reception. To achieve the
best AM reception, it may be necessary rotate the radio.
Seek Tuning
1. Turn on the radio pressing the On/Off button.
2. Select desired band by pressing the Band button.
3. Press and hold the Tuning UP/Down button for approximately 1/2
second. Radio will seek for next active signal station.
4. Repeat as many times as desired.
Manual Tuning
1. Turn on the radio, select desired band.
2. Press Tuning Up/Down button repeatedly until desired frequency is
found.
5