Connecting Up; Rear Panel; Connecting Optical Cords; Connecting Coaxial Cords - Pioneer PDR-W37 Elite Operating Instructions Manual

2 Connecting Up

Rear panel

Important: Before making or changing any rear panel
connections, make sure that all the components are switched off
and unplugged from the power supply.
Connect to the OPTICAL OUT
or COAXIAL OUT of a CD,
MiniDisc, DAT or other digital
equipment for digital recording.
LINE
REC PLAY
IN OUT
Connect to the TAPE/MD/
CD-R LINE IN/OUT jacks
of your amplifier or receiver.

Connecting optical cords

1

Connecting coaxial cords

C O A X IA
8
DIGITAL
IN
L
R
OPTICAL
COAXIAL
1 2
Before plugging in an optical cord, pull
out the protective cover from the
optical jack.
2
Optical interconnects only plug in one
way, so make sure the plug is correctly
lined up with the jack before inserting.
You should hear it click into position
when fully inserted.
Avoid using optical interconnects
longer than 3 meters. Optical
interconnects are available from any
good audio dealer.
Use a regular interconnect with a pin-
type (also called RCA or phono) plug
L
on each end to connect components
with digital coaxial-type jacks. These
are available from any good audio
dealer. Make sure that the plug is
pushed fully home.
Connect to the OPTICAL IN or
COAXIAL IN of a CD-R,
MiniDisc or DAT recorder, or
other digital recording device to
be able to record from this unit.
After completing all other
connections, connect the
power cord and plug into a
CONTROL
DIGITAL standard AC wall outlet.
OUT
IN
COAXIAL OPTICAL
Connect to the CONTROL
OUT of a Pioneer amplifer or
receiver to be able to use the
amp/receiver's remote control
with this unit.

Connecting stereo audio cords

Connecting the control cord

Plugging in

After double-checking all the connections, connect the power cord
to this unit and plug the other end into a standard wall outlet.
Congratulations! You're done setting up.
AC IN
The two sets of stereo audio cords
supplied connect this unit to your
amplifier/receiver's analog line
L I N E inputs/outputs. Be sure to fully insert
each plug for the best connection.
The plugs and jacks are color-coded
to make connection easier.
Use a mono miniplug cord (not
supplied) to connect the
CONTROL
of your Pioneer amplifier or
OUT
receiver to the
CONTROL IN
unit. If you plan to use this feature,
you must also connect the analog
audio / s.
LINE IN OUT
of this